برد کنترلر پرینتر سه بعدی RAMPS ورژن 1.6

This controller board is one of the development boards of Arduino boards and is used in the construction of 3D printer or three-axis CNC. The RAMPS 1.6 board is a shield to convert the Arduino MEGA board into a 3D printer controller, and the combination of RAMPS 1.6 and Arduino MEGA creates a complete control system for 3D printers.

The RAMPS 1.6 controller board in 3D printers supports two extruders and can run five stepper motors, which can be increased by adding an extension board. The A4988 and DRV8825 stepper motor drivers are easily mounted on this board.

1. Install a suitable heatsink for the MOSFETs on the controller board before use.

2. Creating proper ventilation for the controller board will reduce the possibility of injury.

3D printer

Three-axis CNCs

1, 4 layers PCB, optimize heat dissipation.

2, can be extended to LCD and other parts.

3, there are heater and fan MOSFET outputs and 3 thermistor interfaces

4, 5A greater safety and fusion protection component

5, heated bed additional checks 11A fuses

6, applied to 5 Pololu stepper car board

7, Pololu design pin socket socket can be easily replaced or removed for future design

8, I2C and SPI pins are available for future expansion

9, Servo connectors are used for connecting limit stops, motors and light-emitting diodes. These connectors are gold plated and have a nominal current of 3A, which is very compact.

10, the LED lights up when the heater has an outlet

11, choose 2 motors to connect to the Z Prusa Mendell

Support Driver: A4988, DRV8825, TMC2208, TMC2100, TMC2130

Support LCD: 12864 LCD/2004 LCD/ TFT3.5

Compatible With: Mega2560 Board

Input voltage: 12V

Current: 30A

Patch MOS tube: B55NF06

Size: 101.6 * 60.19mm