ماژول مبدل RS232 به TTL دارای تراشه MAX3232 و سوکت مادگی

MAX3232 RS232 To Serial TTL Converter Module is a low power consumption transceiver module convert RS3232 serial port to TTL serial, which is based on MAX3232 transceiver chip. The MAX3232 chip is composed of a dual line driver, a dual line receiver, and a dual circuit of the charge-pump with ±15-kV ESD protection of pin to pin (serial-port connection pins, including GND). It is compliant with TIA/EIA-232-F requirements to interface between an RS232 that is an asynchronous communication controller and the TTL that is a serial port connector. Four small external capacitors make a charge pump to instead of a dual power supply. It can work at data signaling rates up to 250 kbit/s and a maximum of 30-V/µs driver output slew rate.

The MAX3232 module is developed to make easy communication between the TTL serial port and RS232 ports by converting their appreciate signals. This module has a female DB9 connector (soldered at one end) that can directly be connected to a COM port of any PCs, and four header pins with jumper cables (at the other end)

Radio

Flash XBOX360, GPS

Car test

DVD

Hard disk repair

Microcontroller programming

 STC microcontroller

 STM32 microcontroller

 NXP microcontroller

 Renesas microcontroller

 NEC microcontroller

Communication chip: built-in MAX3232

Working voltage: 3.3 - 5.5 volts

Interface: TX RX VCC GND

Dimensions: 30.8 x 28.8 mm

Model number: RS232

Scope of application: switch and sensor for Arduino STM

Interface: TX RX VCC GND (TTL)

Weight: 0.015g