هوالرزاق


دسته بندی
برد آردوپایلوت 2.8
برد آردوپایلوت 2.8 برد آردوپایلوت 2.8 برد آردوپایلوت 2.8 برد آردوپایلوت 2.8 برد آردوپایلوت 2.8

برد آردوپایلوت 2.8

کد انبار : 1251-154-2463
مدل کالا : APM 2.8 Ardupilot
جستارش : A1-06-0303B
موجودی: در حال حاضر موجود نمی باشد. موجودی کالا
قیمت:
3,816,500 تومان

تعداد: - +
   - یا -   

برد آردوپایلوت 2.8 - APM 2.8 Ardupilot

این خلبان خودکار کاملا Open Source است و شما به همه ی سورس های نرم افزاری و سخت افزاری آن دسترسی دارید. با استفاده از این ماژول می توانید، هلیکوپتر، هواپیما، مالتی کوپتر و حتی ماشین و قایق های مدل را کاملا خودکار کنید  و با توجه به اینکه این ماژول قابلیت آدرس پذیری از GPS را دارد با بکار گیری GPS میتوانید ماموریت های مختلفی را برای آن تعریف کنید.
برد فلایت کنترل APM امکانات و قابلیت های زیادی را دارد که کارآیی این برد پروازی را افزایش داده است. بر روی فلایت کنترل APM سنسورهای فشارسنج هوا، ژیروسکوپ سه جهته، شتاب سنج، قطب نما قرار گرفته اند که اطلاعات پروازی، اطلاعات حرکتی، ایستایی بر روی چیپ دیتافلش با ظرفیت 4 مگابایت ذخیر می شود تا بتوان از اطلاعات به دست آمده، شرایط بهتری را برای پرواز فراهم کرد. جهت پردازش اطلاعات از میکروکنترلرهای ATMEGA2560 و ATMEGA32U  استفاده می شود.
از جمله مهم ترین قابلیت های این خلبان پروازی امکان اضافه کردن گیمبال و کنترل از طریق موبایل است که با برقراری ارتباط از طریق وای فای و بلوتوث می توان امکانات دیگری را به برد اضافه کرد.

کاربرد APM 2.8:

  1. هواپیما بدون سرنشین

مشخصات APM 2.8:

  1. ولتاژ ورودی: 16 ~ 12 ولت 
  2. پردازنده: ATMEGA2560 and ATMEGA32U-2
  3. ابعاد: 15 × 45 × 70 میلی متر
  4. اسلات کارت حافظه ندارد
  5. دارای ژیروسکوپ سه محوره 
  6. مجهز به سنسور فشارسنج 
  7. دارای چیپ دیتافلش 4 مگابایتی 
  8. سازگار با GPS, uBlox
  9. دارای پورت ارتباطی I2C  وتغییر آن به پورت های ارتباطی UARTO, UART2, I2C, OSD
  10. استفاده از خازن تانتالیوم 4.7 میکروفارادی جهت حذف نویز و تثبیت ولتاژ تغذیه
  11. سازگار با برد آردوینو

مستندات:
راه اندازی APM 2.8 Ardupilot


Description:
This is the new APM 2.8 autopilot module. The sensors are exactly the same as with APM2.6, however this version does not have an onboard compass, which makes this version ideal for use with multicopters and rovers. The APM 2.8 is a complete open source autopilot system and the bestselling technology that won the prestigious 2012 Outback Challenge UAV competition. It allows the user to turn any fixed, rotary wing or multirotor vehicle (even cars and boats) into a fully autonomous vehicle; capable of performing programmed GPS missions with waypoints. Available with top or side connectors. This revision of the board has no onboard compass, which is designed for vehicles (especially multicopters and rovers) where the compass should be placed as far from power and motor sources as possible to avoid magnetic interference. (On fixed wing aircraft it’s often easier to mount APM far enough away from the motors and ESCs to avoid magnetic interference, so this is not as critical, but APM 2.6 gives more flexibility in that positioning and is a good choice for them, too). This is designed to be used with the 3DR uBlox GPS with Compass (see option below), so that the GPS/Compass unit can be mounted further from noise sources than APM itself.

Features:
Input Voltage: 12-16 V.
Processor: ATMEGA2560 and ATMEGA32U-2
Atmel’s ATMEGA2560 and ATMEGA32U-2 chips for processing and USB functions respectively
Dimensions: 70 x 45 x 15 mm
Micro SD card slot: No.

Includes 3-axis gyro, accelerometer, along with a high-performance barometer
Onboard 4 MegaByte Dataflash chip for automatic datalogging
Barometric pressure sensor upgraded to MS5607, from Measurement Specialties.

The interface is changed from 1.0mm 6P SM06B GPS to DF13-4P I2C external compass interface, put DF13- 5P GPS interface with external compass interface.
The I2C interface has been changed to multifunctional MUX interface, users can configure the interface like UARTO, UART2, I2C, OSD, default OSD interface
2.8 ADOPTS LP2985-3.3, the voltage reaches 16V,increase the reliability, reduce the voltage problem probability of Bad Gyro health
uses jumper cap to choose, find the MAG pins on board, plugging in jumper cap is built in compass, taking off jumper cap is external compass
Added a 47 uf tantalum capacitor, improve APM on-board chip, the stability of the power supply.
Arduino Compatible
Weight: 30g

از این پس درج نظرات صرفا از طریق سامانه آفتاب یار امکان پذیر می باشد، برای وارد شدن به صفحه کالا بر روی لینک زیر کلیک کنید:
http://aftabyar.com/page/aftab-1251.html
AftabRayaneh©2022