دستگاه خم پلاستیک و پلکسی گلاس

Acrylic is a transparent thermoplastic homopolymer known more commonly by the trade name “plexiglass.” The material is similar to polycarbonate in that it is suitable for use as an impact-resistant alternative to glass (particularly when the high impact strength of PC is not required). It is generally considered one of the clearest plastics on the market. Some of the first applications were in WWII when it was used for submarine periscopes as well as airplane windows, turrets, and canopies. Airmen whose eyes were injured due to shards of broken acrylic fared much better than those affected by shards of shattered glass.

Place the arc bender and angle bender straighter (using the arc bender and the lower end of the angle bender to balance) the acrylic edge panel, clamp the acrylic edge strip in place and fit the heating plate to the edge strip. It can soften the edge strip, remove the arc bender and angle bender, bend the softened edge strip literally at an angle, and bend it at an angle, and fix it with glue to complete the hot bending of the arc angle. The force of the splint should be moderate. Excessive force makes the lower end of the heating plate not fit tightly. Because the lower end of the edge strip is joined to the panel, the heat loss is large. The upper end should be stricter, and the proper pressing force of the heating plate should be mastered in use so that the edge strip can be heated up and down evenly. Hot bend within 150mm. Due to the short warm-up time of this product, restarting will not waste too much time. If it is not used for more than 5 minutes, please turn off the power switch to save energy. Do not put the heating plate on the power cord to avoid danger. Unplug the power cord for a long period of time and wait for the temperature to fall below 50 ° C before storing it.

industry

Building

signs panel making

Making maquette

Build a robot

Voltage: 100 ~ 240V

Power: Arc 60W and Angle 39W

Heating Temperature: 200 Centigrade ±5%

Arc Heater size: 100mm x 50mm x 2mm

Angle Heater Size: 100mm x 2.5mm x 2mm

Bending Letter Height: 0 ~ 100mm

Bending Thickness: 1.5mm ~ 4mm

Arc bending soft time (2.5mm thickness, 20 Centigrade): About 9 seconds

Angle bending soft time (2.5mm thickness, 20 Centigrade): About 3 seconds