هوالرزاق


دسته بندی
تستر قطعات الکترونیکی LCR-T7
تستر قطعات الکترونیکی LCR-T7 تستر قطعات الکترونیکی LCR-T7 تستر قطعات الکترونیکی LCR-T7 تستر قطعات الکترونیکی LCR-T7

تستر قطعات الکترونیکی LCR-T7

کد انبار : 1760-116-3158
مدل کالا : LCR-T7
جستارش : B2-19-0401A
موجودی: 40
قیمت:
800,550 تومان

تعداد: - +
   - یا -   

تستر قطعات الکترونیکی LCR-T7

این محصول یک تستر الکترونیکی چند منظوره LCR-TC7 است که می تواند برای تشخیص ترانزیستور NPN و PNP ، خازن، مقاومت، دیود، تریود، N-channel و P-MOSFET ، IGBT ، JFET ، Triac، باتری و غیره مورد استفاده قرار گیرد. همچنین می تواند برای تشخیص شکل موجهای مادون قرمز، دیود زنر مورد استفاده قرار گیرد و عملکرد کالیبراسیون خود را نیز شامل می شود.
پین های قطعه ی مورد نظر را در قسمت مربوطه قرار دهید ، سپس دسته کوچک را بزنید و آشکارساز به طور خودکار آن را آزمایش کند ، در آخر ، نتایج به وضوح روی صفحه TFT نمایش داده می شوند.
توجه:
قبل از اتصال خازن ها به تستر الکترونیکی ، آن ها را تخلیه کنید! تستر ممکن است قبل از روشن شدن آسیب ببیند. در پورت های MCU فقط اندکی محافظت وجود دارد. در صورت تمال به تست اجزای نصب شده در مدار، احتیاط بیشتری لازم است. در هر صورت ، تجهیزات باید از منبع تغذیه جدا شوند و شما باید مطمئن باشید که هیچ ولتاژ باقیمانده در تجهیزات باقی نمانده است.

کاربرد تستر الکترونیکی LCR-TC7 :

  1. تعمیرات قطعات الکترویک

مشخصات تستر الکترونیکی LCR-TC7 :

  1. صفحه نمایش TFT 160*128
  2. دکمه چند کاره
  3. قابلیت تست ترانزیستور و دیود زنر   0.01-30V
  4. مجهز به دریافت کننده IR
  5. رابط شارژ میکرو USB
  6. کالیبره اتوماتیک با قابلیت Self-test
  7. پشتیبانی از Hitachi IR coding
  8. قابلیت خاموش شدن خودکار
  9. قابلیت تشخیص ولتاژ باتری Li-ion

مستندات:
آنباکسینگ LCR-T7


Description:
This is an LCR-TC7 Multi-functional Electronic Component Tester that can be widely used to detect NPN and PNP transistor, capacitor, resistor, diode, triode, N-channel, and P-channel MOSFET, IGBT, JFET, Triac, and battery, etc. It can also be used to detect infrared waveforms, Zener diode and includes the function of self-calibration.
After detection, align the infrared remote control with the “IR” light, then press the button on the remote control, if the detector successfully decodes it, it will display the data code and infrared waveform.
One button operation automatically detects and shutdown, and you can press the multi-functional button to close the detector too.
Put the pins of the component in the corresponding area, then dial the little handle and the detector will test it automatically, finally, the results will display on the backlight TFT screen clearly.

Attention:
All ways are sure to discharge capacitors before connecting them to the Tester! The Tester may be damaged before you have switched it on. There is only a little protection at the MCU’s ports. Extra caution is required if you try to test components mounted in a circuit. In either case, the equipment should be disconnected from the power source and you should be sure, that no residual voltage remains in the equipment.

Specification:
160x128 TFT display
Multi-function key
Transistor test area
Zener Diode test area
IR receiver window
Micro USB Charging Interface
Charge indicator LED

Features:
Automatic detection of Zener diode 0.01-30V
Self-test with automatic calibration
Support Hitachi IR coding
IR waveform display
Infrared receiving instruction
Measurement results using TFT graphic display(160x128)
One key operation
Auto Power Off(Timeout Settable)
Li-ion Battery voltage detection
Support Chinese and English

از این پس درج نظرات صرفا از طریق سامانه آفتاب یار امکان پذیر می باشد، برای وارد شدن به صفحه کالا بر روی لینک زیر کلیک کنید:
http://aftabyar.com/page/aftab-1760.html
کالاهای مرتبط (1)
AftabRayaneh©2022